Wellcraft 180 SPORTSMAN O/B, Руководство пользователя, Страница: 151 / 180

1. Pour a solution of 1 quar t (approx. 1 liter) of
vinegar and 5 gallons (19 liter s) of fresh
water into tank.
2. Allow solution to stand in tank for se veral
days.
3. Drain entire system and flush with fresh
water.
IMPORTANT: Thoroughly flush entire system
with fresh w ater after treatment.
INITIAL START-UP
1. Sanitize the system as described abo ve.
2. Fill the fresh w ater tank with drinking w ater.
3. Operate the faucet until a steady flow of
water is visible.
4. Refill the tank to capacity if necessar y.
DOCKSIDE WATER HOOKUP
As an alter native to the fresh w ater tank, the
system can be connected to a dockside w ater
supply. Because the w ater enters the boat
under pressure, it b ypasses the fresh w ater
tank, filter and pump. The pump should be shut
off when the system is connected to dockside
water.
NOTE: Using dockside w ater does not replenish
water supply in your tank. The tank can only be
filled at the fresh w ater fill plate.
The fresh w ater system operates at a low er
pressure than that supplied from a dockside
water source. Unless the pressure is regulated,
dockside water may rupture lines or leak
through gaskets. Monitor the w ater system care-
fully the fir st time you hook it up to the
dockside water system because the system is
connected to an unlimited supply of w ater. The
dockside water inlet on your boat ma y be
equipped with a pressure regulator to reduce
the pressure of the w ater supplied to your
boat’s system. Check with your dealer if you
have a question.
To connect dockside w ater:
1. Turn the FRESH WATER PUMP switch off.
2. Remove the threaded plug from the female
swivel hose connector of the w ater inlet fit-
ting. Be sure to clean both ends and flush
the hose before connecting . Foreign matter
may damage the pressure regulator .
3. Attach the proper sanitar y drinking w ater
hose to the w ater inlet fitting .
4. Before connecting the dockside w ater outlet,
open the valve fully to flush a way any rust
particles which may be present.
5. Connect the hose to the dockside w ater outlet.
WATER HEATER
Your boat is equipped with a w ater heater to
provide hot w ater to the fresh w ater system. A
breaker marked WATER HEATER on the A C con-
trol panel controls the operation of the heater .
The heater will not operate using DC power.
Some models ma y have an adjustable ther mo-
stat to regulate hot w ater temperature. Check
with your dealer for the capacity of the w ater
heater.
IMPORTANT: Before turning the w ater heater
circuit breaker ON, mak e sure the w ater heater
4-12
NEVER leave the boat unattended
while using the dockside water
hookup. If a line ruptures or other
major leak develops, excess water in
the bilge could damage the engines or
other boat components, or – worse yet
– the excess water could sink your
boat. Turn the water supply off before
leaving.
CAUTION
!
Before connecting to any water fitting
be sure the water is potable and suit-
able for human consumption. Also, a
special sanitary drinking water hose is
required for the potable water connec-
tion. Do not use a common garden
hose for drinking water.
WARNING
!
60305-Fishboat-04_05_Sect 1/13/04 3:27 PM Page 4-12