5
SMP Encoder & Transcoder Quick Installation Guide
V1.0-N
2. Operation Instructions
2.1
Powering Up & Initializations
Before powering-up the device, make sure that all cables are correctly
connected (refer to chapter 1.2). The device is correctly connected to the power inlet
and grounded.
Switch on the equipment through the back power switch, the unit is powered up and start the
initialization.
The LCD screen is lighted up, and display information as following:
The initialization takes about 20 seconds to complete.
If the unit fails to initialize and hangs at the “booting” stage, swtiching off the
device and then powering up again may help. If the device still fails to initialize,
please contact your service representative for help.
2.2
Network Connection Setup
2.2.1 Navigation Keys Operation Instruction
Use the 6 navigation keys on front panel: Up / Down / Left / Right / Menu / Ok to
enter the configuration menu.
z
Enter “Menu”:
Press
“
MENU
” button to enter main menu.
z
Exit Menu/Back to parent Menu
Upon completion of configuration settings, press “
MENU
” button until you go back
to the Parent Menu.
You can also go back to Parent Menu directly by pressing “
ESC
” button once.
z
Enter Sub-Menu
SMP
Encoder
&
Transcoder
Setting
subboard1……
