WELDPRO MIG155GD, Руководство оператора, Страница: 31 / 36

3. Remove the thumb screw and spring tensioner that holds the wire spool on (FIG. J1).
4. Place wire spool on spindle and replace the thumb screw with spring tensioner and tighten till the point that the spool has
some tension on it.
5. Loosen the Brass Tensioner Thumb Screw (FIG. J2) until it is possible to feed the welding wire through the drive roller
grooves.
6. Feed the wire by hand from the spool into the inlet guide, (FIG. J3) past the drive rollers and into the wire inlet (FIG. J4).
7. Tighten the Brass Tensioner Thumb Screw (FIG. J2) until it applies light pressure onto the welding wire. If this is too tight it
will deform the wire and cause feeding issues, if it is too loose the drive roller will slip on the wire.
8. Remove the nozzle and contact tip.
1. Replace the wire spool cover.
2. Plug in welder to your power source and turn on the welder.
3. Trigger the Spool Gun to feed the wire and adjust the Brass Tensioner Thumb Screw (FIG. J2) so that the wire does not
slip.
4. Replace Contact Tip and Nozzle.
5. Feed wire through the gun and cut the wire exposing a ~1/4" length out of the contact tip.
***Please remember also if you are unsure of any connection or any process, at anytime if you have any questions, please
contact technical support at 651 329 2686 we are available 7 days a week from 9 a.m. to 9 p.m. eastern time.
J1
J2
J3 J4
30