WELDPRO MIG155GD, Руководство оператора, Страница: 30 / 36

4. Once your regulator and hose is connected, slowly and carefully open your C25 supply tank very slowly so as to prevent
your regulator flow valve ball from hitting the top of the regulator harshly.
5. Once you gently cracked open your supply tank you can open it completely, back seating it in the full open position.
Tapping your trigger button on your MIG torch will start the gas flow so that you can adjust the gas to the proper flow.
Based on whether your regulator is marked in cubic feet per hour CFH or liters per minute LPM will determine whether it
should be set respectively at approximately 20 or 10.
6. Being sure your mode button is set to the MIG mode, refer to the remaining portion of the manual for any additional
needed information on settings so that you may begin welding.
29
SET UP FOR SPOOL GUN WELDING
The WELDPRO MIG155GD is set up to use a spool gun which allows for easy feeding of aluminum wire to expand your welding
capabilities. This is an optional accessory and can be purchased separately from WELDPRO.
1. Switch the selector switch to the Spool Gun position.
2. Open the side door of the welder and loosen the Torch Tensioner located on the side of the drive roller. If the standard
welding gun is installed remove it and its associated connector.
3. Slide the brass body of the Spool Gun in through the front of the unit in the designated hole. Be sure to insert until it
bottoms against the drive assembly or a gas leak may occur.
4. Connect the metal plug to the gun trigger connection on the front of the welder.
5. Tighten the Torch Tensioner finger tight.
WARNING
DANGER ELECTRIC SHOCK HAZARD!
Turn welder off and unplug from power source before installing or removing Spool Gun.
SET UP FOR SPOOL GUN WELDING
DANGER
ELECTRIC SHOCK HAZARD!
Turn welder off and unplug from electrical outlet.
WARNING
WELDING WIRE CAN BE DANGEROUS!
1
.
Never point the welding gun at any part of the body, other people, or metal surfaces.
2. Wear safety glasses and handle welding wire safety as it can be sharp and cause injury.
1. Set the switch above the drive motor to the spool gun setting (FIG. B2).
2. Remove the thumb screw and clear plastic wire spool cover.