WELDMAN
SEMI-AUTOMATIC LCD POWER MIG 210 MIG / MAG / MMA / TIG DC LIFT
Page 6
VI.
WELDING
As soon as the welder is ready to go, we proceed to setting the operating parameters
MIG / MAG and FLUX
PREPARATION FOR WELDING
During preparation for work MIG / MAG after the general steps you should also follow the steps below:
welding torch
In the case of preparing a welder to work MIG / MAG welding torch before connecting to welding should pay attention to choosing the right
wire diameter, and then check whether it has been established the appropriate guide wire wire (FE: 0,6-0.8 wire blue wire, wire
1.0-1.2 red wire; AL .: 0.8 blue conductor wire, wire cable red 1.0) and the contact tip of the torch.
Installation Teflon liner for aluminum welding
holder Euro MIG / MAG:
AND.
Remove the retaining nut
AND.
Remove the retaining nut
B.
Pull the insert with a steel handle
B.
Pull the insert with a steel handle
C.
Insert a Teflon liner for aluminum
C.
Insert a Teflon liner for aluminum
D.
Install the mounting nut
D.
Install the mounting nut
E.
It should be noted that the pad
E.
It should be noted that the pad
protrude from the holder so
that after insertion of the handle reached the wire
feed roller
Attaching the wire
•
open the side cover welder
•
ensure that the rollers in the dispenser are correctly attached and are in accordance with the diameter and the type of the wire
(steel wire - Roll V grooves, aluminum wires - the roller with grooves U)
•
set up the spool of wire 200 mm (max 5 kg), and secured against falling (left-hand thread on the nut mounting spool)
