WELDMAN
SEMI-AUTOMATIC LCD POWER MIG 210 MIG / MAG / MMA / TIG DC LIFT
Page 7
•
cut off the deformed tip of the wire on the spool and round it
•
release the pressure roller and insert the wire into the sleeve in back of the tray and the guide wire on the driving roller to a fitting,
welding torches
•
reset the pressure roller and check if the wire is properly placed in the drive roller
•
Remove gas nozzle and current nozzle out of the holder
•
enable the welder, then press the trigger in the handle until the wire
•
set up a current nozzle and the gas nozzle
•
adjust the pressure adjustment knob and check that the wire does not slide in the groove
•
close the side cover
SETTING THE PARAMETERS
Control Panel
As soon as the welder is ready to go, we proceed to set the operating parameters on the panel:
1. Welding mode selection screen
1. Welding mode selection screen
multipurpose knob (5) to select one of the function 9 (8
relates to a welding process and the Settings 1) by
pressing the knob (5) accept selection
2. External screen settings
2. External screen settings
It indicates the wiring, the composition of shielding
gas, depending on the welding method, and then
pressing the knob (5) accept selection
3.
Diameter of said screen
3.
Diameter of said screen
It allows you to select the correct
diameter of the electrode / wire,
pressing the knob (5) accept selection
4. Screen the thickness of the weld material
4. Screen the thickness of the weld material
to set the proper thickness of the welded material
pressing the knob (5) accept selection
