13
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts imme-
diately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use
solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened.
To tighten the cables, first insert the weight pin (not
shown) into the center of the weight stack (not
shown). Next, locate the Large Pulley Plates (95).
Remove the M10 Nylon Locknut (57) and the M10 x
50mm Bolt (64) from the Large Pulley Plates, the
upper 90mm Pulley (27), and the Cable Trap (51).
Reattach the Pulley and the Cable Trap to the
Large Pulley Plates using a hole closer to the cen-
ter of the Large Pulley Plates.
Make sure that the
Cable Trap is in the proper position and that the
High Cable (30) is between the Cable Trap and
the Pulley.
To further tighten the cables, change the
position of the lower 90mm Pulley (27) in the same
way.
Another way to tighten the cables is to change the
position of the 90mm Pulley (27) attached to the
“U”-bracket (18). Remove the M10 Nylon Locknut
(57) and the M10 x 50mm Bolt (64) from the “U”-
bracket, the Pulley, and the Cable Trap (51).
Reattach the Pulley and the Cable Trap to the “U”-
bracket using the higher hole in the “U”-bracket.
Make sure that the Cable Trap is in the proper
position and that the Low Cable (31) is between
the Cable Trap and the Pulley.
57
64
Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight
stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and
reinstall it.
If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of
this manual.
MAINTENANCE
57
30
27
31
51
51
18
64
95
27
27
