20
49. Route the Ab Cable (66) through the Butterfly
Upright (2). Attach a 100mm Pulley (38) inside
the Leg Lever Base (5) with an M10 x 65mm Bolt
(80), two M10 Washers (99), two 12.5mm
Spacers (69), and an M10 Nylon Locknut (101).
50. Note: This step is shown from the back of the
weight system.
Lay the Ab Cable (66) in the indicated brackets.
Attach a 100mm Pulley (38) inside the bracket on
the Base (1) with an M10 x 45mm Bolt (51) and
an M10 Nylon Locknut (101).
51. Wrap the Ab Cable (66) over a 100mm Pulley
(38). Attach the Pulley and a Long Cable Trap
(68) to the second set of holes from the bottom of
the two Pulley Plates (41) with an M10 x 50mm
Bolt (81) and an M10 Nylon Locknut (101). Make
sure the Cable Trap is oriented to hold the
Cable in the groove of the Pulley. Make sure
the Cable is routed over the Pulley toward the
front of the Butterfly Upright (2).
49
50
51
52
38
38
51
80
66
66
2
99
99
101
101
Brackets
101
69
69
5
1
38
66
81
38
68
101
2
2
81
41
52. Note: The following steps are shown from the
back of the weight system.
Wrap the Ab Cable (66) under a 100mm Pulley
(38). Attach the Pulley and a Long Cable Trap
(68) to the Butterfly Upright (2) with an M10 x
50mm Bolt (81) and an M10 Nylon Locknut (101).
Make sure the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
68
66
