14
34. Locate the Long Cable (54). Route the Cable
over a 90mm Pulley (58), and up through a
Swivel Arm (32) and the Left Upright (3). Attach
the Pulley inside of the Swivel Arm with an M10 x
53mm Button Bolt (147), two M10 Washers (84),
two 6mm Spacers (75), and an M10 Nylon
Locknut (79).
35. Route the Long Cable (54) over a 90mm Pulley
(58). Attach the Pulley and a Small Cable Trap
(63) to the left Side Top Frame (13) with an M10 x
49mm Button Bolt (104) and an M10 Nylon
Locknut (79).
Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
36. Route the Long Cable (54) under a 90mm Pulley
(58). Attach the Pulley and two Half Finger
Guards (40) to a Base (1) with an M10 x 46mm
Button Bolt (100) and an M10 Nylon Locknut (79).
37. Route the Long Cable (54) around a 110mm
Pulley (59). Attach the Pulley, a Long Cable Trap
(62), an M10 Washer (84), and a Large Full
Finger Guard (150) to the Center Base (2) with
an M10 x 76mm Button Bolt (102) and an M10
Nylon Locknut (79).
Make sure that the Cable
Trap is turned to hold the Cable in the groove
of the Pulley.
79
34
84
75
84
32
3
58
54
147
75
79
13
63
58
54
104
37
54
58
40
40
79
1
100
36
79
54
59
84
150
62
102
2
33. Attach the Low Cable (72) to the “U”-bracket (47)
with an M6 Washer (86) and an M6 Nylon
Locknut (80).
See the inset drawing. Do not
overtighten the Locknut; it should be threaded
onto the end of the Cable so that only two
threads are showing past the Locknut.
33
72
47
86
80
72
45
47
35
