8
6.
Orient the Left Spotter (24) as shown. Slide the
Spotter and two Guide Bumpers (27) onto the left
Guide Rod (5). Engage the Spotter onto the Left
Upright (3).
Repeat this step with the Right Spotter (not
shown) and the right Guide Rod (not shown).
8.
Attach a Barbell Adapter (22) to one end of the
Weight Bar (17) with an M10 x 25mm Button
Screw (98), an M10 Split Washer (93), and an
M10 Large Washer (76).
Repeat on the other
end of the Weight Bar.
Tighten an M8 x 20mm Hex Screw (21) into the
Left Guide (20).
Repeat with the Right Guide
(not shown).
9.
Insert a Rod Cap (33) into a Side Top Frame (13).
Set the Top Frame onto the left Guide Rod (5)
and into the Left Support (6).
Attach the Side Top Frame (13) to the Left
Upright (3) and the Left Support (6) with two M10
x 73mm Button Screws (103), two M10 x 25mm
Button Screws (98), four M10 Split Washers (93),
and four M10 Washers (84).
Do not tighten the
Screws yet.
Insert an M10 x 67mm Button Bolt (90) through
the Left Upright (3) and the Side Top Frame (13).
Hand tighten an M10 Washer (84) and an M10
Nylon Locknut (79) onto the Bolt.
Repeat this step with the other Side Top Frame
(13) and the right side of the weight rack.
7.
Slide the Right Guide (19) and the Left Guide
(20) onto the Guide Rods (5).
Slide the Weight Bar (17) through the Left Guide
(20), the Locking Bar (18), and the Right Guide
(19). Engage the Locking Bar onto the Uprights
(3, 4).
27
6
7
24
5
3
27
19
18
20
17
5
3
4
5
21
20
17
8
9
22
76
93
98
90
13
84
6
84
79
33
93
98
84
93
5
3
103