WEIBANG SC409H, Руководство оператора

Страница: 23 / 32

20
Is the drive belt tension set properly? Refer to “Replacing Drive V-Belt and
Pulley” for details.
Does the drive belt show signs of wear and tear? Replace if necessary.
Is the blade & rotor assembly in good condition? Are any blade worn down to
minimum length of 3”/7.6 cm? If so, have they been replaced?
Are the safety warning labels and other decals clearly identifiable and legible? If
not, ensure that fresh decals will be re-applied prior to use for operator safety.
Is the frame and handle in good condition with no visible damage or rusting? If
not, contact local dealer to replace machine prior to further use.
Are all fasteners in good working condition? Tight all loosen fasteners.
Does the machine run with excessive vibration? If so, please contact your
dealer for solutions.
10.2 Preventative Maintenance Procedures
Maintaining a regular cleaning and lubrication schedule as well as taking time to perform
preventative maintenance procedures will prolong the service life of the sod cutter. The following
are guidelines to setting up a regular maintenance routine for the sod cutter.
1. Cleaning the WBSC409H
Regular cleaning will help extend the service life of the machine.
i.
After each use, the sod cutter, in particular the blade should be cleaned. Scrape the
bottom of gear box and blade to remove accumulations of leaves or trash.
ii.
Clean the engine often, to keep trash from accumulating. A clogged engine runs hotter
and shortens engine life
。
iii.
We do not recommend using a garden hose to clean the sod cutter, unless the
electrical system, muffler, air filter and carburetor are properly covered to keep out
water. Water in the engine can result in a shorter engine life.
Take care when using a power pressure washer to clean the unit, and avoid damaging
any safety or operating instruction decals. Avoid directly spraying bearings, chains or
engine. DO NOT USE ANY MACHINE RATED HIGHER THAN 1000 PSI.
Iv. Beware of damaging any warning decals and labels, as well as the drive belt, bearings
and engine. Limit direct spray on these objects to help prevent their wear and tear.
v. For easier access to cleaning the sod cutter, the machine may be tipped on its engine
guard for NO MORE THAN 2 MINUTES. Engine damage may result from gasoline
flowing into the crankshaft due to prolonged tipping.
2. Lubrication Schedule
Regularly scheduled lubrication of the wheels, blade & rotor assembly, and linkage joints in
the carriage is essential to smooth performance and extended equipment life. The following
schedule is a recommended guide to lubricating your WBSC409H. The schedule should be
adjusted for various environmental conditions and frequency of use.
Item Suggested
Lubricant
Every 20
hours Every 60
hours As
required After each
Pressure wash Storage
Engine Refer to Owner's √