WEIBANG SC409H, Руководство оператора

Страница: 16 / 32

13
appropriate for the job and jobsite requirements
WARNING: Before operating the machine, be sure to read all safety, controls and operating
instructions in this Owner’s Manual and on decals located on machine.
Server personal injury or property damage could result if this instruction is not followed.
Before starting the machine
1.
Read and understood all the sections in this manual
.
2.
Make sure the oil is the grade recommended by engine manufacturer. (Refer to engine
operator’s manual
）
3.
Make sure the gear selecting lever is in neutral position before starting the machine.
4.
Make sure the blade is disengaged and set in upper position for traveling before starting the
machine.
7.1 STARTING AND STOPPING THE ENGINE
DANGER: Do not operate the engine in an enclosed area. Engine exhaust contains carbon
monoxide, a deadly gas that is odorless, colorless and tasteless. Always run engine
outdoors and make sure there is adequate ventilation.
To start the engine
1) Move the machine to a level area.
2) Move the engine chock control lever to choke setting to start a cold engine.
WARNING:
To avoid injury, look behind you to be sure there are no obstacles before pulling recoil
starter rope.
3) To start engine using recoil starter:
A: Stand on left side (as viewed from behind handlebars) of machine.
B: Grasp starter rope handle and pull slowly until rope pulls slightly harder. Let rope rewind
slowly. Then pull rope with a rapid, full arm stroke. Let rope return slowly.
C: when engine starts, operate in fast throttle setting (move throttle from choke setting to fast
setting slowly to engage the blades).
CAUTION: When you pull the engine starter knob to start the engine, please stop the
operation and check the causes in case the engine fails to start in 30 second after repeated
starting operation. See trouble shooting.
To stop the engine
1. Move throttle from fast setting to slow position.( Whenever possible, gradually reduce engine
speed before stopping engine.)
2. Move the throttle control all the way to stop position.