WECO 5K3-XP-EMEA
13
General Preparation
Before Installation:
Ensure that all the modules are turned OFF.
Ensure the enclosure is free from damages dents or any deformations caused by impacts.
Battery installation location should be at least 20m away from sources of heat, protected from any source of sparks free
flames and any other sources of extreme temperature.
Battery connecting cables shall be as short as possible to prevent excessive voltage drops.
Battery installation must be away from any GAS, FUEL or any INFLAMMABLE GAS OR LIQUID, The internal contactor and
electronic devices can cause internal sparks during the normal usage
Batteries with different capacity, different type/model or design or from different manufacturers shall not be connected
together.
1.
Before connecting the battery, the battery positive and negative poles shall be carefully
checked to ensure correct installation.
2.
The installation location must be on a flat level surface, in a dry, clean and protected room,
away from water and humidity.
The mechanical installation method for the WeCo 5K3-XP Battery Modules can be considered
“conceptually’’ the same for HV and LV configurations
, the operator must read this manual in full.
Before starting any operation on the battery, make sure to position the modules in their final position
and structurally fix all the modules that make up the system on a previously verified surface.
The wall mounted bracket is instead to be used only for low voltage applications
Stack Mounted configuration is suitable for both LV and HV configuration
The installer who intends to install the WeCo 5K3-XP Battery Module in the HV configuration should
read this entire manual including the LV configuration information contained in this manual