26
WWW.WEBER.COM
®
LIGHTING THE ROTISSERIE BURNER
ROTISSERIE BURNER SNAP IGNITION
Note: Each control knob snap igniter creates a spark from the igniter electrode to the
burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning to “START/HI”. This will ignite each individual burner.
ATTENTION: READ BEFORE
LIGHTING ROTISSERIE BURNER
After a period of non-use, before lighting the Rotisserie
Burner, a few seconds must pass for the gas supply line to
fi ll.
When using the snap igniter you will see a fl ash of fl ames
moving from left to right across the Rotisserie Burner
surface, the Rotisserie Burner is not lit until the entire
ceramic surface is afl ame.
At this point, start a count of 20 seconds before releasing the
Rotisserie Burner control knob.
The Rotisserie Burner surface will glow red once the burner
is fully ignited.
DANGER
Failure to open the lid while igniting the grill, or not waiting
5 minutes to allow the gas to clear if the grill does not light,
may result in an explosive fl are-up which can cause serious
bodily injury or death.
1
6
2
5
3
4
S-650
* The grill illustrated may have slight
differences than the model purchased.
CAUTION: The Rotisserie Burner fl ame may be diffi cult to
see on a bright sunny day.
WARNING: Check hose before each use of grill for nicks,
cracking, abrasions or cuts. If the hose is found to be damaged
in any way, do not use the grill. Replace using only a Weber
®
authorized replacement hose. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com
®
.
1) Open
the
lid.
2)
Remove the warming rack and the cooking grates from the cookbox.
3)
Make sure all burner control knobs are turned to “OFF”. (Push control knob in and
turn clockwise to ensure that it is in the “OFF” position.)
4)
Turn on the gas at source.
WARNING: Do not lean over the open grill.
5)
Push the control knob in and turn to “START/HI”. This action will spark the
igniter and light the Rotisserie Burner. Continue to use the snap igniter until the
Rotisserie Burner has ignited. Release the control knob.
6)
Check that the burner is lit by looking for the rotisserie burner to glow red.
3
5
WARNING: If the rotisserie burner does not light, turn the
burner control knob to “OFF” and wait 5 minutes to let the
gas clear before you try again or try to light with a match.
Note: When using the rotisserie with the lid closed, only light two of the main burners
on each side of the food (See Grilling Methods-Indirect Cooking). Check your food
periodically to prevent over cooking on the outside. Turn off the rotisserie burner once
the food has browned to the desired color. Finish cooking on Indirect heat.
TO EXTINGUISH
Push in and turn the rotisserie burner control knob clockwise to “OFF” position. Turn gas
supply off at the source.
OPERATING INSTRUCTIONS
Содержание S-620/650
Страница 5: ...5 WWW WEBER COM 5 EXPLODED VIEW S 620 VISION CLAT E DIAGRAMA DE DESPIECE S620_NG_US...
Страница 7: ...7 WWW WEBER COM 7 S650_NG_US EXPLODED VIEW S 650 VISION CLAT E DIAGRAMA DE DESPIECE...
Страница 10: ...10 WWW WEBER COM 6 7 8 ASSEMBLY ASSEMBLAGE ENSAMBLAJE 3 3...
Страница 11: ...11 WWW WEBER COM 11 11 10 9 1 2 S 650 3 ASSEMBLY ASSEMBLAGE ENSAMBLAJE 2 2...