26
mAINTENANcE
eLeCtroniC iGnition sYsteM oPerAtions
If the Electronic Ignition System fails to ignite, be sure there is gas flow by attempting to
match light your burners . Refer to “MAIN BURNER MANUAL IGNITION” . If match lighting
is successful, the problem lies is the electronic ignition .
m
wArninG: All gas controls and supply valves should be in
the off position.
• Verify that the AA battery (alkaline only) is in good condition and installed correctly
(1) . Some batteries have a plastic protective wrap around them . This plastic must be
removed . Do not confuse this plastic with the battery label .
• Make sure the ignition wires are attached to igniter module properly. Refer to the
“IGNITER MODULE WIRE GUIDE” below .
• Make sure the ceramic igniter assembly is fully positioned into burner tube igniter
channel
(2) . If properly positioned, you will hear a snap (3) .
• Make sure the Electronic Ignition button is working by listening and looking for sparks
at burner .
if the electronic ignition system still fails to light, contact the Customer service
representative in your area using the contact information on our web site. Log
onto www.weber.com
®
.
◆
IGNITER moDULE WIRE GUIDE 330
1
2
3
4
1
2
3
4
A
B
C
D
wire end & terminal Color
burner tube
Black
(1)
Left Burner
(A)
Yellow
(2)
Right Burner
(b)
Blue
(3)
Center Burner
(C)
Green
(4)
Sear Burner
(d)
IGNITER moDULE WIRE GUIDE 310/320
1
2
3
4
1
2
3
4
A
B
C
wire end & terminal Color
burner tube
Black
(1)
Left Burner
(A)
Yellow
(2)
Right Burner
(b)
Blue
(3)
Center Burner
(C)
Green (Ground)
(4)
Center Burner
(C)
1
2
3