Weber mt DVH 550 L - 2, Руководство по эксплуатации и техническому обслуживанию

Страница: 32 / 40

32 DVH550/600
4 Faults in operation
4.1 General
If a defect fault occurs on the roller then the following procedure must be executed:
- Shut off the roller as described in section 2.7.
- Determine the source of the fault (see section 4.2 Troubleshooting).
- Correct the fault, see section 3 (maintenance tasks) and section 2 (description of the different fastening
elements)
Correction of faults that affect the engine are described in the manual of the engine manufacturer.
The detailed descriptions of the various control elements, localization via the instructions in the maintenance
overview (section 3), and troubleshooting (section 4.2) enable fast fault correction. The prerequisite is precise
compliance with the specified sequence for execution of the repair work.
The repair work must be executed with proper tools and the safety instructions specified in this operating
and maintenance manual must be complied with for all tasks.
If a fault is not eliminated after replacing a component, or a subassembly, the repair must be continued with
execution of the next described activity.
If a fault could not be eliminated even after execution of all specified repair activities, or if the repair is not described
in this operating and maintenance manual, then this fault must be eliminated by authorized service personnel.
4.2 Troubleshooting
Fault Possible cause Remedy Note
Roller does not start
Operating error
Execute start process as
prescribed
# 2.5
Lack of fuel Check the fuel level # 2.4.1
Fuel filter fouled Change the fuel filter
# 3.3.4
Air filter fouled Clean/change air filter cartridge
# 3.3.3
Roller does not move
Operating error Repeat movement attempt
# 2.6
Hydraulic pump is no longer
working
Check the V-belt for the
hydraulic pump, replace if
necessary
# 3.3.9
No vibration
V-belt for the vibration shaft
is defective
Change V-belt # 3.3.5
Roller surface fouled Drums are fouled Adjust the scraper # 3.3.11