WDT DUFTDOS-DS, Руководство по эксплуатации

Страница: 16 / 31

Fragrance Dosing, Type DUFTDOS-DS
Index: 01 Date modified: 20.09.2017 BA no.: BA DW 015-01 Duftdos-DS EN 14168-21659.docx Page 16 of 28
6 Operation / service
General
These tasks must only be performed after the device has been successfully commissioned.
The dosing times and the launch behaviour following startup are preset during commissioning.
DANGER DUE TO ELECTRICAL VOLTAGE!
Any changes to the terminal assignment of the control board must only be carried out
in compliance with the safety instructions, see Section 2.
Terminal assignment see terminal diagram.
Control
Figure 10, Control System
Key
2 Power indicator
Green: ready for operation
3 Potentiometer pause time
Dosing begins once the device is activated, either with a pause time or a dosing time, depending on the
presetting.
When the device is ready for operation, the power indicator (2) will be illuminated green.
6.2.1 Set pause time / dosing quantity
Set the pause time for a dosing cycle (and thereby the dosing quantity) at the potentiometer (3).
When setting the dosing quantity, observe the manufacturer's specifications for the fragrance concentrate.
Tip!
Pause "0" (continuous dosing) is used to vent the dosing line.
Control System - Software
No software available
2
3