85
EN
type of road and constant
braking).
3)
frequent
hills
or
headwinds, as well as roads
in poor condition, can reduce
battery performance,
4) the tyre pressure is not
high enough (inflate them),
5)
frequent
stops
and
restarts,
6) the battery has been
stored without being charged
for a long time.
2)
in
winter
or
at
temperatures below 0°C,
your battery must be kept
indoors,
3) this is a normal cause and
the problem will be solved
with improved conditions,
4) inflate the tyres to a
pressure of 3.1 bar,
5) the problem will be solved
with the improvement of the
usage conditions,
6)
regularly
charge
the
battery in accordance with
the instruction manual. If the
problem persists, contact
your retailer or a qualified
professional.
After connecting the charger,
the charging LEDs do not
light up.
1) problem with the electrical
outlet,
2) faulty contact between the
charger input socket and the
electrical outlet,
3) the temperature is too low.
1) check and repair the
electrical outlet,
2) check and fully insert the
plug,
3) charge indoors.
If the above solutions do not
work, contact your retailer or
a qualified professional.
After charging for more than
4/5
hours,
the
charge
indication LED is still red
(note: it is very important to
charge the battery according
to the instructions to avoid
damaging the equipment).
1) the ambient temperature is
40°C or higher,
2) the ambient temperature is
0°C or lower,
3) the bicycle was not
charged after use, which
exacerbated the decrease in
charge,
4) the output voltage is too
low to charge the battery.
1) charge the battery below
40°C and in accordance with
the instructions,
2) charge the battery indoors
and in accordance with the
instructions,
3) correctly maintain the
battery to avoid exacerbating
the decrease in charge,
4) do not charge with a
voltage lower than 100 V.
If the above solutions do not
work, contact your retailer or
a qualified professional.
LCD display:
The speed is not displayed
on the LCD screen.
The magnetic ball installed
on the spoke of the wheel is
too far from the sensor (fixed
to the rear of the frame or to
the
front
fork),
which
prevents the sensor from
receiving the signal when the
wheel turns.
Check the distance between
the magnetic ball and the
sensor and make sure it does
not exceed 5 mm.
Troubleshooting charger issues: