Wayne CDU980E, Руководство по установке

Страница: 9 / 35

INSTALLATION MANUAL
9
3. Remove obstruction to ensure free motion
of switch 4. Remove obstruction in discharge
piping
5. Contact an electrician.
Pump operates
noisily or vibrates
excessively
1. Worn bearings
2. Impeller obstructed or broken
3. Piping attachments to building
structure too rigid or too loose
1. Replace pump
2. Where applicable, remove screen and volute, clean impeller
and/or replace impeller
3. Install rubber coupling (available at local hardware stores) to
isolate pump vibration from discharge plumbing
Pump will not 1. Switch 1. Replace switch shut off
2. Switch obstructions 2. Remove obstruction to ensure free motion of switch
3. Restricted discharge (obstruction in 3. Remove obstruction from discharge piping piping)
4. Excessive inflow or pump not 4. Recheck all sizing calculations to determine proper pump size
properly sized for application
Pump operates
but delivers little
or no water
1. Low line voltage
2. Inlet screen clogged
3. Broken impeller or debris in impeller
cavity
5. Pump not properly sized for
application
6. Check valve stuck closed or
installed backwards
7. Shut off valve closed
1. Contact an electrician
2. Remove debris
3. Remove screen and volute, clean impeller and/or replace
impeller
5. Recheck all sizing calculations to determine proper pump size
6. Remove and examine check valve for proper installation and
free operation
7. Open valve
ROUTINE SUMP MAINTENANCE
We recommend you check your sump pump for proper operation at least once a year.
•
Make sure the pump is plugged in to a working ground fault circuit interrupter (GFCI) outlet and the cord is in good
shape. In damp areas, GFCI breakers may trip, effectively shutting off the sump pump. Check in on your sump pump and
reset the GFCI if necessary.
•
Ensure the pump itself is standing upright. Vibrations during operation can cause it to fall or tilt onto one side. This
can jam the float arm so it can’t activate the pump.
•
Pour a bucket of water into the pit to make sure the pump starts automatically and the water drains quickly once the
pump is on. If the pump doesn’t start, have it serviced or replaced.
•
Check the inlet screen and clear away any small stones or debris.