3
DEFINITION OF SYMBOLS
WARNING
ATTENTION - Risk Of Injury
WARNING
IT IS VITAL FOR THE SAFETY OF PERSONS TO FOLLOW ALL
INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
1.
READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2.
Wear eye protection when using tools to install, repair or adjust door or opener, to prevent eye injuries.
3.
Wear protective gloves to install, repair or adjust door or opener, to avoid hand injuries.
4.
The door system should not be installed and is not intended for use in an explosive environment.
5.
Door is under extreme spring tension. To prevent possible injury, repairs or adjustments not covered in this manual should only be performed by an
authorized, qualified door system service representative.
6.
Operate door only when properly installed, properly adjusted and free of obstructions.
7.
The door should not be installed in a corrosive environment.
8.
The door is designed to operate in an ambient temperature range of -40°C (-40°F) to 57°C (135°F).
9.
Avoid standing in open doorway or walking through doorway while door is moving. Do not go under a stopped, partially open door.
10. Ensure the label, warning against entrapment, is in a prominent place.
11. After installation, ensure that the parts of the door do not extend over public footpaths or roads.
12. Keep away from the all moving parts of the door and opener system while the system is being operated.
13. Watch the moving door and keep people and objects away from the door until the door is completely closed. NO ONE SHOULD CROSS THE PATH
OF A MOVING DOOR.
14. KEEP THE GARAGE DOOR PROPERLY BALANCED. an improperly balanced door could cause severe or fatal injury. Have an authorized, qualified
door system representative make repairs to the cables, spring assemblies and other hardware.
15. Keep all remote controls away from children and do not allow children to play with garage door or electrical controls. Watch the moving door and
keep people away until the door is completely opened or closed.
16. Use caution when using the emergency disconnect with the door in the open position. Possible unexpected movement of the door could occur.
17. Check that the door reverses when it contacts a 50 mm high object placed on the floor. if the door does not reverse, a hazard may be present. See
Step 15: Contact Obstruction Test.
18. Install any fixed control within sight of the door but away from moving parts and at a height of at least 1,5 m.
19. Ensure the label concerning the manual release is adjacent to its actuating member.
20. Ensure the label warning against entrapment is in a prominent place and near the fixed control, which controls the door (Wall Station).
21. After installation, ensure that the drive prevents or stops the opening movement when the door is loaded with a mass of 20 kg, fixed centrally on the
bottom edge of the door.
22. Disconnect electric power to the garage door opener before removing case covers or making repairs.
23. This product is provided with a power supply cord and unidirectional power plug of a special design. if damaged, cord must be replaced by a cord of
same type obtained from your local Wayne Dalton distributor.
