(4) 1/4”-20 x 5/8”
Carriage bolts (as required)
1/4”-20 x 9/16”
Track bolts (as required)
(2) 3/8”- 16 Hex nuts
(as required)
1/4”- 20 Flanged
hex nuts (as required)
1/4”-14 x 5/8” Self tapping
screws (as required)
(2) 3/8”-16 x 3/4”
Truss head bolts
3/8” - 16 x 1-1/2” Hex head bolts
(as required)
5/16” x 2-1/2” Hex head lag screws
(RED HEAD) (as required)
5/16” x 1-5/8” Hex head lag screws
(as required)
5/16” x 1-5/8” Hex head lag screws
(RED HEAD) (as required)
Door Section Identification
End and center hinges are always pre-attached at the top of each section (except top sec-
tion).
The
BOTTOM SECTION
can be identified by the factory attached bottom weather seal, the
factory attached bottom corner brackets and by the bottom corner bracket warning labels on
each end stile.
The
LOCK SECTION
can be identified having no labels attached to the section.
The
INTERMEDIATE SECTION I
can be identified by the warning label attached to either the
right or left hand end stile.
The
INTERMEDIATE SECTION II
can be identified having no labels attached to the section.
The
INTERMEDIATE SECTION III
can be identified having no labels attached to the section.
The
INTERMEDIATE SECTION IV
can be identified having no labels attached to the section.
The
TOP SECTION
can be identified with no pre-installed graduated end or center hinges.
Section side view illustration
Bottom corner
bracket
Bottom
weather seal
End
hinge
Bottom
weather seal
Intermediate I section
Lock section
Bottom corner bracket warning labels
Bottom section
Warning labels
Top section
End
hinge
End
hinge
Tools Required
Power drill
Socket driver: 7/16”
Level
Drill bits: 1/8”, 3/16”,
9/32”, 7/16”, 1/2”
Ratchet wrench
Tape measure
Pliers / Wire cutters
Flat tip screwdriver
Phillips head screwdriver
Wrenches: 3/8”, 7/16”,
1/2”, 9/16”, 5/8”
3” Ratchet
extension
Sockets: 7/16”,
1/2”, 9/16”, 5/8”
Vise clamps
Hammer
Step ladder
Pencil
Leather gloves
Locking pliers
Safety glasses
Approved winding bars
Saw horses
4
