![Wayne-Dalton 800 Скачать руководство пользователя страница 17](http://html.mh-extra.com/html/wayne-dalton/800/800_installation-instructions-manual_878583017.webp)
www.Wayne-Dalton.com
349981 REV2_05/17/2016
©
Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation
17
Installation
(continued)
14. MOUNTING ...
(continued)
B.
Find a suitable and easily accessible location for the
Junction Box
,
Fig. 4–S(a).
• Locate Junction Box on the wall near the Position Sensor, Crank Handle
Retainer, and Motor, but OUTSIDE the end cover and its full open swing
range. Verify component cables will reach before mounting Junction
Box and that the end cover full open swing range does not interfere with
access to Junction Box.
• Away from heat sources.
• With no interference of moving parts of the door system.
• Where cables can be well secured while preventing unnecessary strain.
• Use the Junction Box exterior mounting fixtures to mount to wall.
(Fasteners not provided.)
• Attach the Hand Crank Interlock switch cable to the Junction box
connector position 2 labeled “HAND CRANK INTERLOCK” See
Fig. 5–J
on
page 28.
C.
Find a suitable and easily accessible location for the
Control Panel
,
Fig. 4–S(b).
• Adjacent to the door, on the wall, about 5 feet above the floor at the
center of the panel (roughly eye level). It may be mounted higher in
commercial applications to reduce tampering.
• Where all moving parts of the door system are visible while at the control
panel.
• Away from heat sources.
• With no interference of moving parts of the door system.
• Where cables can be well secured while preventing unnecessary strain.
• Mount the Control Panel to the wall. (Fasteners not provided.) Use
supplied mounting tabs as necessary.
Fig 4–S(c)
D.
Photoeye
assemblies are factory mounted to their protective shields.
Attach to guides as follows,
Fig. 4–S(c).
1.
Mount the Photoeye Receiver (pre-wired cable) to the lowest guide
assembly bolt so that the Photoeye is aimed toward the opposite guide.
Route the cable up and plug into the Junction Box connector position 4
labeled “Photoeye RX” see
FIG 5-J
page 28
.
2.
Mount the Photoeye Transmitter (long pre-wired cable) to the lowest
guide assembly bolt on the opposite guide, directly across from the
receiver. Route the wire up the guide and over the header to the Junction
Box to connector position 3 labeled “Photoeye TX”
FIG 5-J
, page 28
3.
Photoeyes will be aligned later, when power is applied to the Control
Panel. See page 29 Photoeye Adjustment.
PANEL
PANEL
GUIDE
HOLES FOR CONTROL
INTERIOR MOUNTING
CONTROL
USE APPROPRIATE
FASTENERS FOR
WALL TYPE
Fig 4–S(a)
Fig 4–S(b)
PHOTOEYE
Photoeyes are attached
to their protective shields
at the factory and must
be mounted to the guides
using the hardware provided.
For parking garage applications
Photoeyes may be mounted higher
to prevent the beam from shooting
beneth vehicles.
Use Fasteners
appropriate for
wall material
Junction Box
Mounting Holes
Crank Support
Bracket
Mounting Holes