•
DO NOT DRIVE WHILE DISTRACTED.
Any function that requires your prolonged attention should not be performed
while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may
result in an accident.
•
KEEP THE VOLUME AT MODERATE LEVELS WHILE DRIVING.
Excess volume levels can obscure sounds such as
emergency vehicle sirens or road warning signals and may result in an accident. Continuous exposure to high sound
pressure levels may cause permanent hearing loss. Use common sense and practice safe sound.
•
FOR USE WITH 12V NEGATIVE GROUND VEHICLE APPLICATIONS ONLY.
Using this product other than in its
designed application may result in fire, injury or product damage.
•
MAKE THE CORRECT WIRING CONNECTIONS AND USE PROPER FUSE PROTECTION.
Failure to connect wiring
correctly or use appropriate fuse protection may result in fire, injury or product damage . Ensure proper fusing of all
system power wiring and install a 1-ampere in-line fuse (not included) with the +12V lead to the unit’s power supply
connector.
•
DISCONNECT THE NEGATIVE BATTERY TERMINAL BEFORE INSTALLATION.
Failure to do so may result in fire,
injury or damage to the unit.
•
D O NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING OBJECTS.
Arrange wiring and cables to
prevent obstructions when driving. Cables or wiring that obstruct or hang up on places such as steering wheel, brake
pedals, etc. can be extremely hazardous.
•
DO NOT DAMAGE VEHICLE SYSTEMS OR WIRING WHEN DRILLING HOLES.
When drilling holes in the chassis for
installation, take precautions so as not to contact, puncture or obstruct brake lines, fuel lines, fuel tanks, electrical
wiring, etc. Failure to take such precautions may result in fire or an accident.
•
DO NOT UTILIZE OR CONNECT TO ANY PART OF VEHICLE SAFETY SYSTEMS.
Bolts, nuts or wires used in the
brake, airbag, steering or any other safety-related systems or fuel tanks should NEVER be used for mounting, power or
ground connections. Using such parts may disable control of the vehicle or result in fire.
WARNING
WARNING
This symbol means important instructions.
Failure to heed them can result in serious injury or death.
CAUTION
This symbol means important instructions.
Failure to heed them can result in injury or property damages.
•
STOP USE IMMEDIATELY IF A PROBLEM OCCURS.
Failure to do so may result in personal injury or damage to the
product. Return it to your authorized Wāvtech dealer
.
•
HAVE AN EXPERT DO THE WIRING AND INSTALLATION.
This unit requires special technical skill and experience for
wiring and installation. To insure safety and proper fun
ction, always contact the authorized dealer where you
purchased the product to have it done professionally.
•
INSTALL THE UNIT SECURELY WITH SPECIFIED PARTS.
Be sure to use only the included parts and specified
installation accessories (not included). Use of other than designated parts may damage this unit. Install the unit
securely so that it will not come loose during a collision or sudden jolt.
•
ROUTE WIRING AWAY FROM SHARP EDGES AND MOVING PARTS.
Arrange cables and wiring away from sharp or
pointed edges and avoid moving parts such as seat hinges or rails to prevent pinching or wear. Use loom protection
where appropriate and always use a grommet for any wiring routed through metal.
•
NEVER RUN SYSTEM WIRING OUTSIDE OR UNDERNEATH THE VEHICLE.
All wiring must
be routed, secured and
protected inside the vehicle. Failure to do so may result in fire, injury or property damage.
•
INSTALL THE UNIT IN A DRY AND VENTILATED LOCATION.
Avoid mounting locations where the unit will likely be
exposed to high moisture or heat without adequate ventilation. Moisture penetration or heat buildup may result in
product failure.
•
REDUCE GAIN AND SOURCE VOLUME TO MINIMUM LEVELS FOR INITIAL SYSTEM TUNING AND BEFORE
CONNECTION TO AN AMPLIFIER.
Ensure amplifier power is off before connecting RCA cables and follow proper
system gain setting procedures. Failure to do so may result in damage to the amplifier and/or connected components.
CAUTION
Package Contents:
Main Unit
Terminals
Accessories Required for
Installation
(not included)
:
Mounting Tabs
(detachable)
Ÿ
RCA Interconnects
Ÿ
18AWG Wire
Ÿ
In-line Fuse Holder w/1A fuse
Ÿ
Battery Ring Terminal
Ÿ
Wire Crimp Connectors
Ÿ
Grommets and Loom
Ÿ
Cable Ties
Ÿ
Mounting Screws
1
Multi-Function Remote
Remote Cable
(16.4ft / 5m)
PWR/SPK
GND