+12V
GND
REM OUT
HP
BP
LP
CH3/4
IN
CH1/2
IN
CH5/6
IN
Summed Full-Range
CH5/6 OUT
Type-1, 2 or 4
Summed Full-Range
CH1/2 OUT
RLC
7
Example-4: Factory Amp w/DSP + AUX (6-in/6-out)
Notes:
Ÿ
For factory amplified systems with more extreme volume dependent DSP effects such as EQ or limiters, or for a stand-
alone system where the source volume will not be accessable after installation, select system Type-4 at the multi-
function remote. This enables all remote functions and sets knob priority to master volume control for both Main and
AUX inputs. Independent CH5/6 level mode is also selectable for each source. Once the system is tuned for a specific
source volume where the factory signal is optimized (make note of the volume setting), do not use the factory radio’s
volume again, but instead use the multi-function remote as the system’s sole master volume control.
Ÿ
In this example, all factory amplifier signal outputs are useable without summing, as the front and rear high-pass
crossover points are low enough for aftermarket speakers and it has a dedicated subwoofer channel. Note that when
using the link6’s AUX input for an auxiliary source in addition to the Main input, all speakers must be powered by
amplifier(s) connected to link6’s RCA outputs and not powered directly by the original factory system.
Note:
The link6 can sum up to 3-way factory systems to full-range while also retaining independent remote level control
over CH1/2 and CH5/6 outputs. If using the remote, choose the appropriate system type (see pg4) and set CH1/2’s
output select switch to 5/6 for a separate full-range output for main speakers and use CH5/6’s output for subwoofer(s).
Example-5: Factory 3-way (6-in/4-out)
Rear HP
+12V
GND
REM OUT
RLC
AUX
IN
Type-4
Ÿ
Main Vol
Ÿ
Main CH5/6
Ÿ
AUX Vol
Ÿ
AUX CH5/6
Front HP
Sub LP
CH5/6
OUT
CH3/4 OUT
CH1/2 OUT
Rear HP
Front HP
Sub LP
CH5/6
IN
CH3/4 IN
CH1/2 IN
