Copyright © 2020 Wavesplitter AV Technology
|
Wavesplitter .com
TEL
：
1-510-0651-7800
：
OPERATION MANUAL
System Requirements
An active network connection from a 10G IP switch for control of compatible AV over IP devices.
Installation
1.
Please make sure that all the devices included in the installation are shut down
2.
Connect, as required, to WST-PIP001 (TX) to the sources by HDMI or DP cable and connect a standard RJ45 Cat.6a
Ethernet cable to
“
10GbE
”
port of Transmitter to the RJ45 ports of 10G IP Switch.
3.
Connect, as required, to WST-PIP002 (RX) to the monitors or TVs by HDMI and connect a standard RJ45 Cat.6a Ethernet
cable to “10GbE”
port of Receiver to the RJ45 ports of 10G IP Switch.
4.
Connect WST-PIP003 (Controller) to the same 10G IP Switch via a standard RJ45 Cable.
Note
：
If you are connecting the units to a Gigabit PoE (IEEE 802.3at compliant) switch can skip using the supplied PSU.
5.
Connect the HDMI Port of WST-PIP003 to any 1080P Monitor, you will see the controller WebGUI.
6.
Plug the USB keyboard and Mouse to the USB ports of WST-PIP003, you can process the system setting.
Serial Port Default Settings
Baud Rate
19200
Data Bits
8
Parity Bits
None
Stop Bits
1
Flow Control
None
1
RESET 1~8:
Press any of the 8
buttons to activate the
saved preset associated
with that number.
Infrared
Power
Ground
