Copyright © 2020 Wavesplitter AV Technology
|
Wavesplitter .com
TEL
：
1-510-0651-7800
：
OPERATION MANUAL
Note: When a
receiver’s
HDMI Audio is set to
“Follow
Video in Genlock
Mode”
and scaling on that output has been
disabled (Bypass), the HDMI audio routing selection is ignored and the audio embedded with the HDMI source will
always be output. In these instances a (!) mark will be displayed
.
-
Stop Stream
：
To stop the HDMI audio stream on a single display, drag the display down to the
“Stop”
button at
the bottom of the window, then release the mouse button. To stop HDMI audio on ALL video outputs, drag the
“All”
button down to
the “Stop”
button.
Note: When a
receiver’s
HDMI Audio is set to
“Follow
Video in Genlock
Mode”,
and scaling on that output has
been disabled (Bypass), the independent audio route will be stopped, however the HDMI embedded audio will
continue to be output normally.
5)
Analog Audio Routing
：
Provides drag-and-drop control over the routing of analog audio input streams between all
detected transmitters and receivers.
⚫
Analog Audio Transmitter
：
This section provides drag-and-drop buttons for all analog input sources detected by the
system as well as a button target to stop one or all analog audio streams from being transmitted.
-
Source to Single Receiver Routing
：
To route an analog audio source
to a receiver, click and drag the source’s
button on the left to the preferred receiver on the right side, then release the mouse button.If the routing was
completed successfully, the newly routed source’s
name will appear belo
w the receiver’s name within the
button. Clicking on any source button will change the color of itself, and all currently routed receivers.
Note: Receivers may also be drag and dropped onto sources to
activate a new route.
-
Source to Multiple Receiver Routing
：
To route an analog audio source to multiple receivers at the same time,
click and drag the
source’s button on the left to a Group button or the “All” button on the
right side, then
release the mouse button. If the routing was completed
successfully, the source’s name will appear within all
appropriate buttons.
