•
Avg. type
: Three types of average are available:
arithmetic
,
sliding
and
IS
. See sections
5.6.2 and 5.6.3 below for more information on this function.
•
Avg. interval
: Used to select the time interval for calculation of the average (see section
5.6.2). The available intervals are
10s
,
30s
,
1min
,
2min
,
5min
,
6min
,
10min
,
15min
and
30min
:
•
Log interval
: Used to select the time interval for storage of data in memory (see section
5.6.1). A datum will be stored every ‘Log interval’ seconds (or minutes). The available
intervals are
1s
,
5s
,
10s
,
30s
,
1min
and
5min
.
•
Limit
: Only available for shaped probes (like
WP50
). Used to select the field exposure
limit from which the percent is calculated. Two exposure limits are available:
occupational
(ICNIRP occupational) and
general
(ICNIRP general public).
None
means that no limits will be used and units will not be in %.
•
Erase memory
: Used to erase all the registers of memory.
This will eliminate all the
data held in memory and so this option must be used with care
. As a safety measure
to prevent accidental loss of data, you will need to press 2 keys to validate erasure. The
procedure is as follows:
o
After
Enter
is pressed, the cursor moves to the vertical arrow symbol
↑
.
o
By pressing the
key you gain access to the validation option and the text
Sure?
appears.
o
To validate the erasure, press
Enter
.
o
To exit the option without erasing, press
Back
.
•
Reset reg. ID:
Used to reset to 0 the unique identifier for each register.
•
Language
:
Used to change the language for the system.
•
GPS
: This enables or disables the GPS receiver. To do so, select the
Enabled
or
Disabled
option, then validate with
Enter
. For further details see section 5.6.6.
•
Date setup:
This is used to change the date used by the device. The date has the format
dd/mm/aa
. Use the
keys to select the value (day, month or year) to be changed, and
then use the
keys to change the value. Press
Enter
to save the new date.
•
Time setup
: This is used to change the time used by the device, with the format
hh:mm:ss
. Use the
keys to select the value (hours, minutes, or seconds) to be
changed, then use the
keys to change the value. Press
Enter
to save the new time.
•
Backlight level:
Value from 0 to 4 to increase or decrease the screen backlight.
SMP
autonomy will depend highly on this setting. Press left or right button to change from
Auto to Fixed mode.
o
Auto after 10 minutes without activity backlight will drop to level 0, pressing
any key will restore normal value.
o
Fixed : no backlight saving will be applied
To exit this screen, press
Back
while the cursor is on the list of parameters (left-hand side).
-
13
-
