Page 8
Step 11:
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Step 12:
Open cold water sink faucet to relieve pressure.
Step 13:
Choosing the configuration that fits your plumbing, attach the Adapt-A-Valve™ as illustrated in the
diagrams above.
NOTICE
Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve. Don’t
forget to install the white compression washer with the 3/8” configuration. The Brass Adapters
do not need to be tightened with a wrench, only finger tight.
Green Tube Connection
Step 14:
Location the 1/4” Green tube in the parts bag. Insert the open end of
the tube with the 90° bend into the open 1/4” quick-connect fitting
located behind the Sediment filter. Make sure to push the tube in all
the way to the tube stop.
Step 15:
Take the other end of the 1/4” Green tube and insert into the 1/4” quick
connect fitting on the plastic Adapt-A-Valve. Make sure to push the tube
in all the way to the tube stop.
D
B
Line from
Cold Water
Supply
Faucet
Connection
Faucet Line
Cold
Water
Supply
C
B
A
D
B
Line from
Cold Water
Supply
Faucet
Connection
Faucet Line
Cold
Water
Supply
C
B
A
Adapt-a-Valve Installation
NOTICE
Water supply line to the system must be from the cold water supply line only. Hot water will
severely damage your system.
NOTICE
Do not use Teflon tape with the Adapt-A-Valve™.
For 1/2” Configuration
Parts List for Adapt-A-Valve
Item Description
A
Brass Adapter with black washer
B
Plastic Adapt-A-Valve & black collet
C
White Rubber Washer
D
Brass Adapter with no washer
For 3/8” Configuration