WattAge egret, Инструкция по сборке

Страница: 20 / 36

20
❑
Kwik Bond Thin C/A
❑
# 0 Phillips Head Screwdriver
❑
# 1 Phillips Head Screwdriver
❑
Excel Modeling Knife
❑
Wire Cutters
❑
Electric or Hand Drill
❑
5/64" Drill Bit
❑
Straight Edge Ruler
❑
Pen or Pencil
❑
Masking Tape
❑
4) Slide one servo into the rear servo cutout.
Position the servo so that the servo output shaft is
toward the front of the airplane and on the left side
of the center pod (looking from the rear). See
photo # 35 below.
Photo # 35
Photo # 36
6
9
10
12
14
15
17
INSTALLING THE CONTROL HORN
❑
1) Turn the fuselage upside down and position
the nylon control horn on the bottom, left side of the
elevator.
❑
2) To properly align the control horn, it should
be perpendicular to the hinge line and its center-
line should be 5/8" out from the side of the sub fin,
at the hinge line. The clevis attachment holes
should be located directly over the hinge line.
❑
3) When satisfied with the alignment, use a
drill with a 5/64” drill bit and the control horn as a
guide, and drill the two mounting holes through the
elevator.
❑
4) Set the control horn back into place and re-
align it. Push two 2mm x 12mm machine screws
into the base of the control horn and through the
elevator. See photo # 37 below.
Photo # 37
☛
Make sure that when installing the servo the
servo wire passes through the servo cutout and does
not get pinched between the cutout and the servo.
❑
5) Slide the second servo into the forward servo
cutout. Position the servo so that the servo output
shaft is toward the back of the airplane and on the
right side of the center pod (looking from the rear).
See photo # 36 below.
☛
Make sure that when installing the servo the
servo wire passes through the servo cutout and does
not get pinched between the cutout and the servo.
❑
6) Using a drill with a 1/16" drill bit, drill four
pilot holes into the center pod, one for each of the
mounting screws (included with your radio system).
Using a # 1 phillips screwdriver, install and tighten
the mounting screws to hold the servos in place.
☛
Be careful not to drill all the way through the
center pod.
☛
The rear servo will be the elevator servo and the
front servo will be the rudder servo.
PARTS REQUIRED
❑
{1} 5mm x 345mm Nylon Pushrod Housing
❑
{1} 4mm x 390mm Nylon Pushrod Tube
❑
{1} Nylon Control Horn w/Backplate
❑
{2} 2mm x 12mm Machine Screws
❑
{2} 2mm x 22mm Threaded Rods
❑
{2} 2mm Threaded Clevises
18
19
ELEVATOR PUSHROD
20
21
22
TOOLS AND SUPPLIES REQUIRED
1
4
5
23