WattAge egret, Инструкция по сборке

Страница: 11 / 36

11
❑
5) Install the second flying wire assembly onto
the wing using the same technique as with the first
one. The two metal flying wire mounts should be
installed into the two rear predrilled holes.
❑
6) Look carefully at the machine screw in the
top of the aluminum flying wire stand-off. You will
notice that there is a slot cut into the end of the screw.
This slot should be parallel with the leading edge of
the wing. If it is not, loosen the machine screw and
readjust it, then retighten the screw.
❑
7) Pull both of the flying wires up and slip them
into the slot in the top of the machine screw. See
photo # 10 below.
☛
At this point, leave the flying wires loose. They
will be tightened later after installing the set of fly-
ing wires onto the bottom of the wing.
Photo # 10
PARTS REQUIRED
❑
{2} 45mm Diameter Wheels
❑
{2} 9-1/2" Aluminum Tubes
❑
{2} 7-5/8" Aluminum Tubes
❑
{2} 3mm x 20mm Machine Screws
❑
{2} 3mm Hex Nuts
❑
{2} 3mm x 20mm Machine Screws
❑
{4} 3mm Nylon Insert Nuts
39
29
TOOLS AND SUPPLIES REQUIRED
❑
Pacer Thread-Lock
❑
# 1 Phillips Head Screwdriver
❑
Adjustable Wrench
❑
Needle Nose Pliers
3
MAIN LANDING GEAR
INSTALLING THE ALUMINUM TUBES
5
7
8
30
33
35
43
44
❑
2) Look carefully at both of the 9-1/2" alumi-
num tubes. You will notice on one end of each tube
that there is one 2mm hole drilled through the middle.
☛
The 2mm hole in each tube should be down away
from the bottom of the center pod.
❑
3) Install the two 9-1/2" aluminum tubes onto
the bottom of the center pod, through the hole that is
1-1/4" behind the motor, using one 3mm x 20mm
machine screw and one 3mm hex nut. Orientate both
of the tubes so that they angle out away from the
center pod. See photo # 11 below.
❑
1) Look carefully at the bottom of the center
pod. You will notice that there are three predrilled
holes: one hole 5/8" behind the motor, one hole
1-1/4" behind the motor and one hole in the back
of the center pod.
Photo # 11
☛
Do not fully tighten the machine screw at this
time. Leave it slightly loose.
❑
4) Look carefully at the ends of both 7-5/8"
aluminum tubes. You will notice that one crimped
end is longer than the other crimped end.
☛
The shorter of the two crimped ends should be
mounted to the center pod.
❑
5) Install the two 7-5/8" aluminum tubes onto
the bottom of the center pod, through the rear-most
hole, using one 3mm x 20mm machine screw and
one 3mm hex nut. Orientate both of the tubes so
that they angle out away from the center pod. See
photo # 12 below.
Photo # 12
☛
Do not fully tighten the machine screw at this
time. Leave it slightly loose.