Watkiss Vario, Руководство по эксплуатации

Страница: 90 / 110

86
Bin # lift error (Suction feed bin only) Too much paper has been loaded into the bin
(note that the grey button will not raise or lower the tray). Remove the
stock and reload a smaller quantity.
Bin # miscal A feed/sensor error has occurred during the test set. The bin will recali-
brate automatically, but check the very first set for errors.
Bin # miss A miss feed error has occurred on the bin detailed. This means that the
bin did not feed a sheet in the last set. Check and correct the faulty set
and restart the machine. If the error persists see the Problem Solving
section of the Operating Manual.
Bin # overload An obstruction in the bin is preventing it from lifting correctly. Check and
remove any obstructions. It may be that the stock has not been pushed
fully forward into the bin.
Bin # Part Reset It is necessary to switch the machine off and then on again after 10
seconds before running another test set. If this problem persists, contact
your local Watkiss service department.
Bin # trailing A trailing feed error has occurred on the bin detailed. This can mean one
of two things:
1) The sheet from this bin was delivered late (trailing single feed)
2) An extra sheet was delivered from this bin, slightly behind the first
sheet (trailing double feed)
If the problem persists see the Problem Solving section of the Operating
Manual.
Bin programming error The bins in the collator have not initialised properly. Switch the machine
off and then on again. If the problem persists, contact your local Watkiss
Service Department.
Bin reset An error has occurred in the electronics of the bin detailed. Any number
over 16 relates to a module other than a bin. Restart the machine. If the
problem persists, contact your local Watkiss service department.
Cannot start fold axis chang-
ing The fold axis (size adjustment) of the booklet maker is in the process of
adjusting. Wait for the booklet maker to finish before pressing
.
Cannot start sheets axis
changing The sheets axis (book thickness adjustment) of the booklet maker is in
the process of adjusting. Wait for the booklet maker to finish before
pressing .
Cannot start sidelay under
stitch head The Stitch-Fold stitch heads are positioned over the bottom of the infeed
sidelays. Adjust the stitch heads so that they do not activate the safety
sensors.
Cannot start tray down (Suction feed bin only) One of the trays has been lowered by the operator.
Press the grey button on the bin controls to raise the tray. Press
.
Message Meaning