Watkiss Vario, Руководство по эксплуатации

Страница: 71 / 110

67
Plug the jogger into the socket on the underside of the
floor base via the interconnection cable. The cable will
only fit in one of the sockets (see p.59).
Adjust the direction of the air blast towards the bottom
edge of the stack. For large sheet sizes it will be necessary
to use the extension tubes.
Run a test set and If necessary, adjust the position of the
jogger. Wheel it further in or out so that the paper falls
neatly into the receiving area. A sideways positional
adjustment may also be necessary depending on the size
of the paper and type of stock.
Jogging Adjustment
If necessary, adjust the amount of vibration via the knob
on the side of the jogger (as shown above). Use the
minimum amount of vibration that will successfully jog the
stack.
Using the Jogger with a Bench Top Vario
The Straight Jogger can be interfaced with either a stand-
ard or oscillating bench base. In both cases please refer
to your Watkiss supplier for more information. The Straight
Jogger can be also be used
off-line either independently
or with any of the Vario bases (see below).
Straight Jogger Fed From the Rear
of a Floor Base
Jogging
Adjustment
Local Control
Switch
Mains Input
Mains On/Off
Switch