Watkiss Vario, Руководство по эксплуатации

Страница: 42 / 110

38
BIN LINKING If required, two or more feed bins may be linked to operate
as a single bin. When one runs out of stock, the next bin
in the linked group will automatically take over. This allows
reloading without stopping the machine. Bin linking can
only be enabled when the bins are unlocked i.e. when the
TEST SET
icon is highlighted on the control panel. Press
the grey button on the upper bin to link it with the one
below. This will be indicated by the small green light. The
Vario outline diagram on the control panel will show a
broken line between bins that are linked.
By pressing the red bin on/off button it is possible to select
which bin in the linked group is active (unless
PRENUMBER
in the
BASIC
window is selected).
If the system is locked, pressing the grey button on any
bin will indicate which bins are in the same linked group.
SENSOR OVERRANGE Sensor overrange is indicated after the test set by a slow
flashing red light on the bin in question.
Particularly heavy or opaque stock such as a straw board
backing sheet may cause the bin sensor to go ’over-
range’. This means that the sheet is too optically dense
for the sensor to ’see’ through it. Double feeds will not be
detected but misses, trailing sheets and jams will be
detected as normal.
DIFFICULT PAPERS Whenever feed difficulties are encountered we recom-
mend that you follow two basic guidelines:
• Switch off all the bins except one. This allows you to
concentrate fully on the feed of a single bin.
• Ensure that only one 'remedy' is tried at a time. This
will make it much easier to identify the solution.
The following suggested settings are a recommendation
only. Paper characteristics vary and therefore any partic-
ular stock may require settings different to those shown.