Watkiss Automation Automatic SpineMaster, Руководство по обслуживанию

Страница: 13 / 120

Introduction
•
Routine Maintenance
Watkiss Automatic SpineMaster Service Manual - Edited 17/06/04
1 - 9
ASM Routine Maintenance Schedule
ASM Serial Number : F/W Version :
CHECK LIST CHECKED COMMENTS / NOTES
1. Check all fixing screws are tightened
2. Check drive chains and transverse chain for ten-
sion and wear
3. Lubricate drive chains using chain lubricant. DO
NOT lubricate the transverse chain.
4. Check/clean belts. Use cloth dampened with
soapy water or alcohol (iso-propanol). DO NOT
use blanket wash.
5. Check that the bolster is firmly held by all six cam
bearings
6. Clean out any paper debris
7. Clean the carriage roller and stop (see 4.3)
8. Check the stop is damped correctly and adjust if
necessary (see 4.7.8)
9. Check that the carriage runs square and tight to
the anvil and bolster
10. Check that the bolster is not burred by badly sta-
pled booklets. Deburr if required (see 4.7.9).
11. Check that the carriage parks beyond the booklet
feed slot, but does not hit either end stop. Adjust
the tension in the transverse chain and then reset
the limit sensors if necessary (see 4.7.2)
12. Check holding magnet is secure and correctly set.
(see 4.8.1)
13. Check condition of outfeed leaf springs (257-
511). Replace if necessary.
14. Check the condition of all electrical cables.
Ensure all connectors are seated correctly
15. Check condition of the interface cable between
ASM and trimmer.
Checks completed by : Date :
Table 1:2 ASM Routine Maintenance Schedule