T-360
Page 4 of 35
Coupling Shaft Housing Removal
1.
Remove the hex head screws and lock washers attaching the coupling
shaft housing to the mid-section.
2.
Remove the coupling shaft housing, O-ring and shims. Note that jack
ing screw holes are provided.
NOTE: The coupling shaft and its associated parts may come with the
housing. If not, pull on the coupling shaft to remove.
Figure 5.
Removal of Coupling Shaft Housing
Shims
Lock
Washer
Hex Hd
Screw
Jacking Screw Holes (2)
Coupling Shaft
Housing
Removing the Bottom Section
1.
Invert the case as shown in Figure 3.
2.
Remove lower cap screws connecting the driveshaft housing to the
bottom section. Loosen cap screws connecting housing to case mid-
section.
3.
Remove the cap screws, nuts and lock washers attaching the bottom
section to the mid-section.
4.
Drive the four dowel pins out of the bottom section flange.
5.
Remove the bottom section from the mid-section.
Figure 6.
Removal of the Bottom Section
Dowel Pins
Hex Nut
Lock Washer
Hex Hd Screw
Driveshaft
Housing
Driveshaft
Housing
Cap Screw
