T-360
Page 17 of 35
Front Facing End Yoke
Rear Facing Hydraulic Pump Provision
1.
Use high pressure grease to coat the driven shaft.
2.
Press the bearing to the shoulder on splined end of driven shaft.
3.
Tap the key into place.
4.
Place high pressure grease in the rear bore of the cap.
5.
Tap the bearing into place.
6.
Set the hydraulic pump adapter on cap and secure with hex head
screws and lock washers. Hand tighten only at this stage of reassemb
ly.
7.
With the cap resting on its rear face, position the spacer and driven
sprocket inside the cap.
8.
Take the driven shaft, bearing and key assembled previously and from
the front face of the cap, slide the shaft through the bore in the cap into
the bore of the driven sprocket, spacer and ball bearing lining up the
key in the shaft with the keyway in the sprocket.
9.
Tap into place until the shaft seats.
10. Install O-ring and oil seal in the oil seal housing.
11. Install the oil seal housing.
12. Remove the hydraulic pump adapter and install retaining ring.
13. Tap internal splined end of driven shaft towards front face to seat
assembly.
14. Install O-ring and oil seal in hydraulic pump adapter.
15. Install wave spring and hydraulic pump adapter.
Figure 27.
Front Facing End Yoke
Rear Facing Hydraulic Pump Provision Reassembly of the Driven Shaft
Sprocket
Key
Ball Bearing
Ball Bearing
Driven Shaft
Cap
Spacer
Retaining Ring
Wave Spring
Oil Seal
IL2541
Cap Screw
Cap Screw
Lock Washer
Lock Washer
Oil Seal Housing
O-ring
O-ring
Front
Rear
Hydraulic Pump Adapter
Oil Seal
