T-360
Page 24 of 35
Reassembly of the Drive Shaft and Drive Shaft Housing
Drive Shaft Assembly
1.
File and clean the sprocket faces and check teeth for burrs.
2.
Use high pressure grease in the bore of the drive sprocket.
3.
Press the needle bearings into each end of the bore of the drive
sprocket. Press rounded end of bearing into sprocket bore. Bearings
should set just below the slots in the sprocket.
Figure 36. Needle Bearing Installation into Drive Sprocket
Needle Bearing
Needle Bearing
Drive Sprocket
IL2526
4.
Install pilot bearing on end of drive shaft.
5.
Use high pressure grease on the drive shaft and press into the drive
sprocket assembly.
6.
Check the shift collar (not shown) for proper fit. Do not install at this
time.
7.
Install the thrust washer onto the drive shaft.
8.
Apply grease and install the ball bearing.
9.
If the tachometer option is used, add the tach pulse generator and
spacer required. If no tach is required, install appropriate spacer.
NOTE: Drive sprocket assembly should turn freely.
Figure 37. Drive Shaft Installation into Drive Sprocket
Pilot Bearing
Drive Shaft
Drive Sprocket
Assembly
Thrust Washer
Ball Bearing
Spacer
Spacer
Tach Pulse Generator
