T-360
Page 9 of 35
Rear Facing Hydraulic Pump Provision
1.
Remove the four cap screws that fasten the hydraulic pump adapter
and bearing cover to the cap. Remove adapter and cover. Discard oil
seal.
2.
Straighten tab of the bearing lock washer from slot in bearing lock nut
and then remove the lock nut, lock washer and wave spring.
3.
Under a press, support the assembly on the rear face of the cap and
apply a press load to the end of the driven shaft to press the shaft out
of the bearing, spacer and sprocket.
4.
Remove the bearing, spacer and sprocket from cap.
Figure 15.
Rear Facing Hydraulic Pump Provision
Driven Shaft Disassembly
Sprocket
Key
Ball Bearing
Ball Bearing
Driven Shaft
Cap
Spacer
Bearing Lock Nut
Bearing Lock Washer
Wave Spring
Oil Seal
IL2540
Cap Screw
Cap Screw
Lock Washer
Lock Washer
O-ring
O-ring
Front
Rear
Hydraulic Pump Adapter
Bearing Cover
Front Facing End Yoke /
Rear Facing Hydraulic Pump Provision
1.
Remove the four cap screws that fasten the hydraulic pump adapter
and oil seal housing to the cap. Remove adapter and housing. Discard
oil seal.
2.
Remove the retaining ring and wave spring.
3.
Under a press, support the assembly on front face of the cap and
apply a press load to the end of the driven shaft to press the shaft out
of the bearing, spacer and sprocket.
4.
Remove the bearing, spacer and sprocket.
Figure 16.
Front Facing End Yoke Rear Facing Hydraulic Pump
Provision Driven Shaft Disassembly
Sprocket
Key
Ball Bearing
Ball Bearing
Driven Shaft
Cap
Spacer
Retaining Ring
Wave Spring
Oil Seal
IL2539
Cap Screw
Cap Screw
Lock Washer
Lock Washer
Oil Seal
Hydraulic Pump Adapter
O-ring
O-ring
Oil Seal Housing
Rear
Front
