Waterous CM Series, Руководство по установке, Страница: 53 / 56

53
|
56
Safety Introduction Product Overview Installation
Installing the Anodes and Intake Screens
1 2
3
Use the illustrations and instructions to install the
optional anodes and intake screens for corrosion
protection. Anodes should be mounted on the intake
plumbing, but can be mounted on the discharge
plumbing if no intake mounting pads are available.
1 To install the bolt-on anode, do the following:
• Apply lubricant to the O-ring groove, then
install the O-ring into the anode.
• Secure the anode to the intake pad.
Note: The replaceable elements of the anodes
must make contact with water to be
effective. Do not use paint or any other
coating on the anodes.
2 To install the threaded anode, screw the anode
into the intake mounting pad.
3 To install the intake screen, do the following:
• Press the screen into the counter bore inside
the intake fitting.
• If the screen does not fit tightly, adjust the slot
on the outer edge to provide a secure fit.
Note:
The screen must have strong contact
with the fitting to be effective. Remove
any corrosion, debris, or paint from the
bore that would insulate the fitting.