Waterous CM Series, Руководство по установке, Страница: 34 / 56

34
|
56
Safety Introduction Product Overview Installation
Mounting the Pump
3
4
6
3-Point Mounting Method—
CMC22/CMUC22 (Front-Mounted)
Use the illustrations and instructions to secure the
angle brackets to the frame rails using the 3-point
mounting method. This method is recommended to
compensate for vehicle frame twist in applications
with front-mounted C22 transmissions.
1 After attaching the angle brackets to the intake
adapters, position the pump assembly within
the frame rails.
2 On the driver side, drill 1 hole into the center of
the bracket that goes through the frame rail.
3 Use a screw (3/4 inch), washer, and nut to
secure the bracket to the frame rail.
4 If your pump's discharge flanges are angle-
compensated, adjust the tilt of the pump
assembly by 4°.
5 On the passenger side, drill 2 holes into the
bracket that go through the frame rail. Position
1 hole near each edge of the bracket.
6 Use screws (3/4 inch), washers, and nuts to
secure the bracket to the frame rail.
7 Use a screw (1/2 inch) and lock washer or
thread-lock to secure the front support bracket
to the frame rail.
5
1
2