Waterous 200-B, Инструкция по установке и обслуживанию, Страница: 9 / 54

Waterous 200-B Belt-Driven Installation Guide Rev-
Page 9 of 54
A "universal mounting bracket" for the 200-B is included from Waterous. The bracket
arm is bolted in place, using the vertical extension if needed, and the adjustable mounting
head moved left or right to position the compressor. After the position is determined,
weld the mounting head to the bracket arm to secure the compressor.
Figure 4 Universal Mounting Bracket Figure 5 Adjustable Mounting Head
B. Air Inlet and Filter
The air inlet on the air compressor can be turned in 90° increments because the bolt
pattern is symmetrical. This simplifies installation of the air filter. If you turn the inlet,
you will need longer tubing. Either acquire colored tubing locally or contact Waterous
for the correct lengths and colors.
To change the rotation of the air inlet, disconnect the tubing, unbolt the inlet, rotate
the inlet, and install new tubing.
Mount the air filter, considering the following factors:
Air intake area must be unobstructed.
Air intake tubing should be as short and straight as possible.
Maintenance clearance must be adequate for removing and replacing the
filter.
The filter should be in an area that is unlikely to get wet.
The air inlet tubing (not included) from the filter to the air inlet is usually made of thin-
wall metal tubing and rubber elbows. Plumb it as though it were an engine air inlet.
Do not use flexible exhaust tubing or any material that water or dirt can easily
penetrate.