Waterous 200-B, Инструкция по установке и обслуживанию, Страница: 20 / 54

Waterous 200-B Belt-Driven Installation Guide Rev-
Page 20 of 54
6. Attach the label to the pump control panel.
7. Replace the nuts and knobs on the front of the assembly, making sure to align
the knob indicators to FIXED and RUN.
8. Make sure the knobs do not bottom out on the valve bodies. This will prevent the
system from working properly.
9. Tighten the setscrews.
B. Electric Valves (Solenoids)
The electric valve assembly comes on a mounting bracket with the connecting wires and
connector already installed.
Figure 25 Auto-Sync Control Switch
and Label (electric)
Figure 26 Auto-Sync valve assembly,
front (electric)
1. Install the valves in a convenient location, close enough to the pump operators
control panel to run the control wires.
2. Install the valve control switch and label on the pump operator's control panel.
3. Run the control wire from the valves to the switch and plug the connectors together.
4. Connect the remaining wire to a +12V supply.
5. Secure the control signal wire to the compartment frame.
Note: If there is excess wire, do not coil it. Coils of wire act as antennas, either
receiving or radiating stray EMF signals and interfere with this or other
equipment. Bundle the wire harness back on itself, and secure it in a bundle with
the folded wires parallel to each other.