1
TABLE OF CONTENTS
Preinstallation instructions for dealer
Inside front cover
Specifications
2
Cycle sequence settings
3
Softener System Setup (programming)
4-6
Bypass valve description & diagrams
7
Installation
8-9
Installer settings
Hardness, Override, Regen Time & Time of Day
10
Normal operating & error displays, power loss
11
Low salt warning & resetting it
12
Start- up instructions
13
Replacement parts & valve repair
Front Cover, Drive Assembly and Piston
14
Injector assembly & refill port assembly
15
Drain line 3/4" assembly & flow controls
16
Drain line 1" assembly & flow controls
17
Water meter & bypass valve
18
Installation fitting assemblies & service wrench
19
Control valve servicing
20-24
Troubleshooting procedures
25-26
PREINSTALLATION INSTRUCTIONS
This unit has a control valve which enables the setting of not only the length of each regeneration cycle but also the order
in which cycles (steps of regeneration) occur. The following pages instruct how to set the treatment unit’s sequence of
cycles, cycle times, salt dose, exchange capacity, and gallon capacity/regeneration time. A salt warning option may also
be included.
THE DEALER...
1. Read this page, GENERAL INSTRUCTIONS, INSTALLER SETTINGS, NORMAL OPERATING DISPLAYS, and
LOW SALT WARNING.
2. Complete the CYCLE SEQUENCE SETTINGS.
3. Complete the SOFTENER SYSTEM SETUP.
a. Cycle Times
b. Choose Softener or Filter
c. Set Salt Dose
d. Set Capacity
e. Set How Gallon Capacity Will be Calculated
f. Set Regeneration Time Option
g. Select or Turn Off Low Salt Warning
THE INSTALLER...
1. Read Bypass Valve page.
2. Read GENERAL INSTRUCTIONS, NORMAL OPERATING DISPLAYS, and RESETTING LOW SALT WARNING
(if applicable).
3. Be sure CYCLE SEQUENCE SETTINGS and SOFTENER SYSTEM SETUP are done before leaving for
installation.
4. Follow INSTALLATION INSTRUCTIONS, INSTALLER SETTINGS, TIME OF DAY, and RESETTING SALT
