10
PREMIER 2 SINGLE-SPEED INSTALLATION AND MAINTENANCE MANUAL
WATER TANK REFILL
Steps:
1)
Close the drain valve to the water heater.
2)
Open the cold water supply to the tank.
3)
Open the hot water faucet in the house to bleed air from the system. Then close when full.
4)
Depress the handle on the pressure relief valve to bleed any remaining air from the tank
then close.
5)
If so equipped, unscrew the indicator plug on the motor end of the pump (located in the
Premier 2 unit) until all air is purged from the pump, then tighten the plug. Use vent cou-
plings to bleed air from the lines.
6)
Carefully inspect all plumbing for water leaks and correct as required.
7)
Before restoring electrical supply to the water heater, adjust the temperature setting on the
tank.
• On tanks with both upper and lower elements, the lower element should be turned down to
the lowest setting, approximately 100
°
F. The upper element should be adjusted to 120
°
F to
130
°
F. Depending upon the specific needs of the customer, you may want to adjust the
upper element differently.
• On tanks with a single element, lower the thermostat setting to 120
°
F.
8)
After thermostat(s) is adjusted, replace the access cover and restore electrical supply to the
water heater.
Initial
Desuperheater
Start Up
Figure 12 -
Typical Desuperheater Installation
Cold
Drain Valve
Coaxial
Drain Tee
In
Out
P/T Relief
Valve
Hot
Long
Elbow
Venting
Waste Valve
or Vent
Coupling
Cold
Drain Valve
Coaxial Drain
Tee
Long Elbow
In
Out
P/T Relief
Valve
Hot
P/T Relief
Valve
Venting
Waste Valve
or Vent
Coupling
Drain Valve
Figure 13 -
Desuperheater Installation In Preheat Tank
Do not connect electrical to pre-heat tank.
Содержание AT019D
Страница 20: ......
Страница 21: ......
Страница 26: ...26 PREMIER 2 SINGLE SPEED INSTALLATION AND MAINTENANCE MANUAL Notes...
Страница 27: ...27 PREMIER 2 SINGLE SPEED INSTALLATION AND MAINTENANCE MANUAL...