Waterax STRIKER-2/3, Руководство пользователя

Страница: 24 / 32

WATERAX STRIKER-2/3 Owner's Manual
22 09/2015
13. Using arbor press and assembly tool 700540, apply several light, downward strokes of press ram
until distributor "drops" into body and rests on previous distributor.
14. Slide impeller #22 into position, aligning with previous impeller.
15. Place lockwasher #23 on shaft with locating tab in milled groove. Slightly bend lockwasher tab
downwards to facilitate insertion. Lockwasher tab should still prevent it from rotating on shaft.
16. Apply a small amount of Loctite 290 on lock nut #24 and screw onto shaft with round surface facing
lockwasher. Tighten to a torque value of 250-260 in-lbs / 28-29 Nm . To secure lock nut and prevent
from rotating, bend one side of lockwasher up onto one flat side of hexagon lock nut. Bend the
lockwasher side that is at the opposite side of the milled slot in the shaft.
17. Place O-ring #5 in groove of suction cover #6. Press cover into pump body until it rests on distributor.
18. Install suction cover using screws #7 and lockwashers #8. Tighten screws evenly and firmly to a
torque value of 32-36 in-lbs / 3.6-4.1 Nm .
19. Attach shaft nose #11 using screw #12 and lockwasher #8. Tighten screw firmly to a torque value of
32-36 in-lbs / 3.6-4.1 Nm .
20. Reinstall remaining protective caps and adaptors.
Pump Clamp
Parts breakdown
ID ITEM NO DESCRIPTION QTY
1 700581 A-4460 LEVER, ZINC PLATED 1
2 600122 A-4452 SIDE LINK FOR LEVER, ZINC PLATED 1
3 800426 C-4462-5 COTTER PIN DIN 94 2.5MM X 16MM 3
4 800263 A-4455 CLEVIS PIN FOR LEVER SIDE 2
5 700889 B-4457 PUMP CLAMP BOTTOM HALF 1
6 600110 B-4461 PUMP CLAMP TOP HALF 1
7 800405 A-4454 CLEVIS PIN 1
8 700004 A-4453 EYE BOLT, PLATED STEEL 1
9 700035 A-4456 KNOB FOR TENSION ADJUSTMENT,
ALU.
1
The quick release pump clamp should be inspected on a regular basis. If components appear to be worn,
replace them immediately.
1
6
2
3
4
7
9
8
5