Waterax STRIKER-2/3, Руководство пользователя

Страница: 21 / 32

WATERAX STRIKER-2/3 Owner's Manual
09/2015 19
Removal of Pulley Assembly
1. Remove all the cap screws sequentially.
2. Remove the set screw.
3. For the large driver pulley, insert the cap
screws into the threaded holes of the
bushing. For the small driven pulley, insert
the cap screws into the threaded holes of
the pulley.
4. Tighten the cap screws against the face until
the screw force releases the pulley from the
bushing.
Use threaded
holes to extract
bushing
Remove set
screw
Removing or Attaching the Pump End
All of the STRIKER-2/3 series pump ends have a quick release pump clamp and detachable pump end
which facilitates the servicing of pump units and minimizes down-time in the field by allowing the quick
replacement of pump ends.
To remove pump from engine:
1.
Lift pump clamp lever.
2.
Release tension-adjusting knob at
bottom of clamp.
3.
Remove clamp by tapping bottom end of
each half clamp.
4.
Remove pump from engine.
To attach the pump end to the engine:
1.
Place flexible buffer coupling on engine
coupling pins.
2.
Align flexible buffer coupling holes to
pump end coupling pins and install.
3.
Install pump clamp with the lever on the
top side (tension knob at the bottom).
4.
Finger tighten tension knob located at
bottom of clamp to obtain a light
pressure on clamp ring.
Align pins
and holes
Use buffer
Clamp lever
Tension knob
CAUTION: Apply FINGER PRESSURE ONLY to close pump clamp lever. Excessive pressure will
damage or break the clamp link.
Clamp