29
f) Changing the house code
Press the button shown.
Enter your current PIN. Note the factory default PIN is 1 2 3 4.
Press the button shown.
The conformation light shown on the keypad will illuminate once and
flash twice.
Enter your new house code. The house code MUST only be each
number once, and starting from the lowest number (e.g. 1234 or 13589
or 3456 or 789 or 79 or 6789).
Press the button shown.
The confirmation light shown on the keypad will illuminate once and flash
3 times to confirm that the PIN has been successfully changed. If the
light does not flash then wait 5 seconds and redo this procedure.
If you have a new keypad, or have changed the house code, this procedure will add keypad to the system.
Note: If you require more than one keypad to work with the system, you must set the house code to the same
on both units.
g) Adding a keypad to the system
Place DIP Switch 1-4 up
Press the ADD button
(Next two steps must be completed within 3 seconds
from pressing ADD)
Enter your current PIN. Note the factory default PIN is 1 2
3 4
Press the button shown.
The confirmation light shown on the keypad will illuminate
once and flash twice.
Test your keypad will now Arm and Disarm the alarm after
returning all DIP Switches to off.
ADD
A
