11
b) Set-up and learn-in a wireless PIR detector
Open the front cover of the detector and remove the plastic insulator from the
battery. Wait 3 minutes for the detector to warm up.
Set the dipswitch to ON for the zone you wish to learn the detector into.
Press the ADD button on the Main Control Unit.
Remove the front cover of the detector.
Press and release the tamper switch. The Main Control Unit should then
beep a number of times; to indicate which zone the detector has been learnt
into.
The system will now automatically enter Walk Test mode.
Walk test the detector and adjust the facing angle as necessary so that the
red light on the detector turns on whenever you walk past it. The unit will
beep out the zone number of the detector whenever it is triggered (i.e. zone 1
will beep once).
The unit will not beep out the zone number if the radio signal strength is not
strong enough.
Mount the detector if the walk test was successful.
Set all the dipswitches to off.
