3. Equipment use and specifications
Micromatic water purification equipment provides Type II purified water (ASMT) from the tap water.
The equipment combines several processes to supply purified water (pre-filtration, reverse osmosis and deionisation).
The water provided by the equipment is suitable for numerous laboratory techniques, preparation of culture media and other
applications requiring Type II purified water.
Once the equipment has been connected and started up, operation is automatic.
The purified water of the Micromatic equipment is not fit for human consumption.
3.1 Electrical Power Requirements:
110 - 230V AC / 50 - 60 Hz Single-phase / 36W.
Use only the transformer supplied with the equipment.
The power point should not be situated below the equipment.
Power consumption 24 VA
System voltage 24 Vdc
Feed water requirements:
Drinking water (according to European or USA standards)
Maximum Inlet
pressure
6 bar.
Minimun. Inlet
pressure
3 bar
Temperature:
5ºC – 35ºC
Maximum hardness:
300 ppm
(CaCO
3
)
SDI (Silt Density
Index)
< 5
Conductivity
< 800
µ
S/cm
Free Chlorine:
<1 ppm
Turbidity:
< 1 NTU
Deviation from the feed value requirements may cause deterioration of the equipment components and/or a decrease in
performance.
Ambient temperature
Operation:
5ºC – 35ºC
Storage:
5ºC – 35ºC
The ambient temperature and, above all, the feed water temperature affect the equipment's performance.
The ideal operating temperature is in the range between 20 - 25°C.
If the equipment may be submitted to low temperatures, make sure it is no less than 5°C.
Relative humidity HR = No condensation. HR < 80% for Temp. up to 31°C (linear decrease up to 50% at 40°C).
