WÄRTSILÄ LAZ 5100, Техническое руководство

Страница: 70 / 79

Technical Manual LAZ 5100 / ES 5100
INSTALLATION, CARE AND MAINTENANCE
5-8 Technical Manual LAZ 5100 / ES 5100 TH 52 603 8001 EN Rev.: S
Access to the
SERVICE MENU
is gained by pressing any
CURSOR
key. The word
NO
will change to
YES
. Press the
ENTER
key and the
SERVICE MENU
, shown
below, will appear.
Figure 5-4 Service Menu
The
SERVICE MENU
allows the service technician to access the following sub-
MENUS:

Channel 1 :
allows selection of Draft, Trim, Blocking Depth, Frequency and
Location for the Channel 1 transducer.

Channel 2 :
allows selection of
Draft, Trim, Blocking Depth, Frequency
and
Location
for the
Channel 2
transducer, if fitted. If no second channel is fitted, this
MENU
is not available

Interfaces :
allows selection of parameters for data transfer.

Display 15 min :
altering the selection of the recording display time.
In order to set or alter the parameters for Channel 1, call up the CHANNEL 1 MENU,
as follows:

Call up the SERVICE MENU as previously described

CURSOR (1x, to mark Channel 1)

ENTER (1x, to call up the Channel 1 parameters
MENU
as seen below)
Figure 5-5 Channel 1 Menu
Channel 1 >> To call up Channel 1 parameter MENU
Channel 2 >> To call up Channel 2 parameter MENU
Interfaces >> To call up interface parameter MENU
SERVICE
Display 15 min ON ON - OFF
Channel 1 >> To call up Channel 1 parameter MENU
Channel 2 >> To call up Channel 2 parameter MENU
Interfaces >> To call up interface parameter MENU
SERVICE
Display 15 min ON ON - OFF
Channel 1 >> To call up Channel 1 parameter MENU
Channel 2 >> To call up Channel 2 parameter MENU
Interfaces >> To call up interface parameter MENU
SERVICE
Display 15 min ON ON - OFF
Power Adjust Norm Adjust Norm
Norm +1dB, +2dB, +3dB, +4dB, +5dB
-2dB, -1dB
Draft 0.0 (0.0..29.9 m)
Trim 0.0 (0.0...4.9 m)
Blocking Depth 0.0 (0.0...2.9 m)
CHANNEL 1
Frequency 50 (24, 28, 33, 38, 50, 100, 200 kHz)
Location BOW (BOW, AFT, Stb., Pt.)